Powerful and chemical-free - the ARKA Aquatics myAqua1900 reverse osmosis system uses the power of water pressure and filters up to 99 percent of salts, bacteria and pollutants such as nitrite or phosphate and heavy metals from conventional tap water. The ratio of osmosis water to residual water is just 1:1-1.5. Thus effectively treated, the water becomes a safe feel-good ambience even for marine and freshwater inhabitants.The system does not require any chemical additives - it works via water pressure and natural filter materials, without chemical additives. Which makes the retention rate very high.   Filter performance: up to 1900 liters / day   Osmosis water to residual water: yield approx. 1:1-1.5    Operating pressure: 1 to 4 bar   Temperature: 5 to 38 degrees   Salt retention capacity: 98% - 99%The system components carbon and fine filter (cartridge) as well as the membrane filter are subject to the following replacement intervals:   Membrane filter: 12 - 24 months from commissioning    Fine filter: 6 - 12 months from commissioning   Carbon filter C1: 6 - 12 months from commissioning   Carbon filter C2: 6 - 12 months from commissioningTip: Filters are consumables and must be replaced regularly! So that their pets always enjoy consistently high water quality, stockpiling is recommended. All three system components (carbon, fine and membrane filters) are available separately.Note: The following accessories are included in the scope of delivery:Water tap, 150 cm hose, 300 cm hose, T-piece including valve, wall mounting,TDS meter, wastewater clamp, water connection (3/4"-1/4"),shut-off valve (1/4"-1/4").

Why RO Water? Pipe water. is usually contaminated with various pollutants, which, depending on its quality can have negative effects on the aquarium. For example, it can cause Algae and diatom blooms favor, which then must be fought with chemical Methods must be fought.Reverse osmosis water is essentially free of chlorine, nitrates, phosphates and heavy metals, and is an ideal basis for the production of saline solutions saline solutions, but also for freshwater aquariums or as a substitute for Evaporation losses.The D-D reverse osmosis plant works according to a three-stage system:1. A 10" 5 micron pre-filter that removes sediment and particles from the water to protect the membrane from clogging and extend its life. prolong its life. The pre-filter is housed in a membrane so you can monitor the life of the disposable element. monitor the life of the disposable element. We recommend that you replace this filter element at a maximum interval of 6 months to change.2. A 10" block carbon filter with 10 microns. This carbon filter removes the chlorine from the water. This element should also be be changed. 3. The. RO membrane and housing. In this phase is the membrane itself. All D-D membranes are high quality thin film membranes.All D-D reverse osmosis systems come complete with the following accessories:- Flow limiter with integrated valve- adapter for tap connection- tap connection with thread- 2 m 1/4" RO hose in white, blue and orange- Sewage line return valve- Filter key- Complete Guidedimensionsheight:  39 cmdepth:  13 cmwidth:  35 cm

Why RO Water? Pipe water. is usually contaminated with various pollutants, which, depending on its quality can have negative effects on the aquarium. For example, it can cause Algae and diatom blooms favor, which then must be fought with chemical Methods must be fought.Reverse osmosis water is essentially free of chlorine, nitrates, phosphates and heavy metals, and is an ideal basis for the production of saline solutions saline solutions, but also for freshwater aquariums or as a substitute for Evaporation losses.The D-D reverse osmosis plant works according to a three-stage system:1. A 10" 5 micron pre-filter that removes sediment and particles from the water to protect the membrane from clogging and extend its life. prolong its life. The pre-filter is housed in a membrane so you can monitor the life of the disposable element. monitor the life of the disposable element. We recommend that you replace this filter element at a maximum interval of 6 months to change.2. A 10" block carbon filter with 10 microns. This carbon filter removes the chlorine from the water. This element should also be be changed. 3. The. RO membrane and housing. In this phase is the membrane itself. All D-D membranes are high quality thin film membranes.All D-D reverse osmosis systems come complete with the following accessories:- Flow limiter with integrated valve- adapter for tap connection- tap connection with thread- 2 m 1/4" RO hose in white, blue and orange- Sewage line return valve- Filter key- Complete Guidedimensionsheight:  39 cmdepth:  13 cmwidth:  35 cm

For perfect living conditions in marine aquaristics / aquatics plays the properly prepared water a fundamentally important role.Here comes an osmosis plant into play.In an osmosis plant, the source water is pressed through a membrane and thus only the finest water molecules get through.Pollutants, heavy metals, lime or chlorine are held back and flushed out via the waste water of the osmosis plant.Back remains the clean osmosis water which you need as a basis for the aquarium.The specified values are dependent on the quality of the input water, the temperature and the age of the membrane.Tested at 20 degrees and 8Bar pressure. A deviation of up to 30% is quite in the normal range.OsmoPerfekt MINI 190 Ltrl. ( osmosis system )with mounting stand, 1 x Membranne GPD 50, 5" fine filter, 5" carbon filter Without connection hose

For perfect living conditions in marine aquaristics / aquatics plays the properly prepared water a fundamentally important role.Here comes an osmosis plant into play.In an osmosis plant, the source water is pressed through a membrane and thus only the finest water molecules get through.Pollutants, heavy metals, lime or chlorine are held back and flushed out via the waste water of the osmosis plant.Back remains the clean osmosis water which you need as a basis for the aquarium.The specified values are dependent on the quality of the input water, the temperature and the age of the membrane.Tested at 20 degrees and 8Bar pressure. A deviation of up to 30% is quite in the normal range.OsmoPerfekt MINI 380 Ltrl. ( osmosis plant )1 x Membranne GPD 100 , 5" fine filter, 5" carbon filter Without connection hose Weee Nr.: DE 93443018Instruction

For perfect living conditions in marine aquaristics / aquatics plays the properly prepared water a fundamentally important role.Here comes an osmosis plant into play.In an osmosis plant, the source water is pressed through a membrane and thus only the finest water molecules get through.Pollutants, heavy metals, lime or chlorine are held back and flushed out via the waste water of the osmosis plant.Back remains the clean osmosis water which you need as a basis for the aquarium.The specified values are dependent on the quality of the input water, the temperature and the age of the membrane.Tested at 20 degrees and 8Bar pressure. A deviation of up to 30% is quite in the normal range.OsmoPerfekt MINI PLUS 475 Ltrl. ( Osmosis system )with mounting stand,  pressure armature, 1 x membranene GPD 125, 5" fine filter, 5" carbon filter, connection hose. Weee No: DE 93443018Filter speed in L/h: * 20Maximum filter capacity in 24h in L:* 475Filter stage 1:  5my PP sediment filterFilter stage 2: Activated carbon block filterFilter stage 3: High performance osmosis membraneFilter size: 5 inchMembrane size: 125 GPDPressure booster pump: noSolenoid valves: 0min. Line pressure: 3 barWastewater ratio:  approx 1:4instruction

OSMO 50 FVM - 189 l/t - real 4 l/h - 96 l/t Consists of:- Sediment filter 9" ¾ 5 micron- Block carbon filter 9" ¾- Membrane (1 gallon = 3.785 liters)- Pressure gauge and purge valve .

OSMO300 - Membrane 300 GLD - 1134 l/ton - real 24 l/hr - 576 l/ton Consists of:- Sediment filter 9" ¾ 5 micron- Block carbon filter 9" ¾- Membrane (1 gallon = 3.785 liter)- Pressure gauge and purge valve .

OSMO100 - Membrane 100 GLD - 378 l/ton - real 8 l/h - 192 l/ton Consists of:- Sediment filter 9" ¾ 5 micron- Block carbon filter 9" ¾- Membrane (1 gallon = 3.785 liter)- Pressure gauge and purge valve .

OSMP100 membrane 100 GLD - 378 l/t* - real 8 l/h - 192 l/t Consists of:- Sediment filter 9" ¾ 5 micron - Block carbon filter 9" ¾ - Membrane (1 gallon = 3.785 liter) - NO3-PO4-SiO2 Filter